The DX1PED pedestal Mount pictured above is
available with any one of three types of Cb radio brackets or an adjustabe
radio bracket. The radio bracket is included. Select the specific item(s) you
would like on right.
September 2016: This item is not currently available.
(1)C529PED Pedestal mount (6" long) and radio bracket for Cobra 29 and
Uniden PC78. (Approx 7" wide)
(2)C525PED Pedestal mount (6" long) radio bracket for Cobra 25 and
Uniden PC68 radios. (Approx 6.5" wide.
(3)Dx1PED Pedestal mount (6" long) and radio bracket for most 10
meter radios (export size), Galaxy, Connex, Ranger, also Cobra
148, Uniden Grant xl and other radios that use 4 mounting side screws.
(Approx 7.5" wide)
(4)C526PED Pedestal mount (6" long) and "Adjustabe width" radio bracket.
Fits most Cb radios, 10 meter radios and scanners.
Pedestal Mount PED1 is 6 inches long (pictured below)(No Radio Bracket).
Use with your existing bracket or purchase a radio bracket sepatately. This has
4 holes near each coner of the top plate to mount your existing radio bracket
to. You may need to drill holes in your existing radio bracket to match it.
Pedestal Mount Extensions PE4", PE6", PE8" or PE10"
pictured below are for the above pedestal mounts.
Note: You can come back to this page
after clicking "Add To Cart" to select other mounts.
Note: Four sheet metal screws are usually used at the
bottom of the mount to secure it to the vehicles floorboard (not included).
The center of the pedestal shaft comes apart by
removing set screws. This is where the extension is inserted. You will need to remove one metal peg from the mount or
For the PED1 the hole in one end of the extesion must
sometimes be drilled out with a 9/16" bit to make the hole
slightly larger for the PED1 mounts metal peg (peg not visible
until PED1 shaft is separated).